Difference between revisions of "IPC2B: USB3.0 Driver Installation Guide"
From fit-PC wiki
Line 1: | Line 1: | ||
+ | * This application note provides a step by step guide to install USB3.0 drivers over Windows 7. | ||
+ | * This guide is applicable to IPC2-Broadwell machines. | ||
+ | |||
+ | ==Instructions== | ||
* Install the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_Chipset.zip Chipset driver] driver before the USB3.0 driver | * Install the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_Chipset.zip Chipset driver] driver before the USB3.0 driver | ||
* Download the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_USB30.zip USB3.0 driver] | * Download the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_USB30.zip USB3.0 driver] | ||
Line 12: | Line 16: | ||
* Follow the on-screen instructions | * Follow the on-screen instructions | ||
* At the the end of installation process, reset the unit | * At the the end of installation process, reset the unit | ||
+ | |||
+ | [[Category:IPC2]] | ||
+ | [[Category:software]] | ||
+ | [[Category:Application notes]] |
Revision as of 13:41, 15 October 2018
- This application note provides a step by step guide to install USB3.0 drivers over Windows 7.
- This guide is applicable to IPC2-Broadwell machines.
Instructions
- Install the Chipset driver driver before the USB3.0 driver
- Download the USB3.0 driver
- Open the donloaded package
- Run the OfflineSetup32.exe file for Windows 7 32bit or the OfflineSetup64.exe file for Windows 7 64bit
- Follow the on-screen instructions
- At the the end of installation process, reset the unit
- Enter the BIOS menu by pressing the F2 key during the boot
- Browse to the Advanced -> South Bridge Configuration -> SB USB Config menu and set the xHCI Mode setting to Enabled
- Press the F10 key for Save&Exit
- When the Windwos boot up, open the donloaded package
- Run the Setup.exe file
- Follow the on-screen instructions
- At the the end of installation process, reset the unit