Difference between revisions of "Getting fitlet CPU temperature in Linux"
From fit-PC wiki
(Created page with '=== install sensors utility (if not installed) === $ sudo apt-get install lm-sensors === load kernel module (if was not autoloaded) === $ sudo modprobe k10temp === get data f...') (change visibility) |
(→install sensors utility (if not installed)) (change visibility) |
||
| Line 1: | Line 1: | ||
| + | The procedure below is validated on kernel 3.16 and later. | ||
=== install sensors utility (if not installed) === | === install sensors utility (if not installed) === | ||
$ sudo apt-get install lm-sensors | $ sudo apt-get install lm-sensors | ||
Latest revision as of 08:42, 27 May 2015
The procedure below is validated on kernel 3.16 and later.
install sensors utility (if not installed)
$ sudo apt-get install lm-sensors
load kernel module (if was not autoloaded)
$ sudo modprobe k10temp
get data from thermal sensors
$ sensors
You should receive something like:
fam15h_power-pci-00c4
Adapter: PCI adapter
power1: N/A (crit = 4.54 W)
k10temp-pci-00c3
Adapter: PCI adapter
temp1: +60.2°C (high = +70.0°C)
(crit = +105.0°C, hyst = +104.0°C)
