Difference between revisions of "FC3-SC-S1C1 FACET3 Card"
From fit-PC wiki
Line 22: | Line 22: | ||
== FC3-SC Rev 1.2 Extension schematic == | == FC3-SC Rev 1.2 Extension schematic == | ||
[[File:FC3-SC Switches.png|600px]] | [[File:FC3-SC Switches.png|600px]] | ||
+ | ==Explanation:== | ||
+ | ===DB9 Port #2=== | ||
+ | ====CAN #2 switches==== | ||
+ | '''SW3''': '''Code''' - switch between '''UART/USB''' presentation <br> | ||
+ | '''SW4''': '''Term''' - Termination by '''120 OM''' if needed | ||
+ | ===DB9 Port #1=== | ||
+ | |||
+ | ====SER #1 switches==== | ||
+ | '''SW8''': Switch between '''RS232''' and '''RS485'''<br> | ||
+ | '''SW7''': Switch between '''Full''' and '''Half''' duplex (for '''RS485''')<br> | ||
<!-- | <!-- | ||
===Instructions=== | ===Instructions=== |
Revision as of 08:54, 24 October 2023
Contents
FC3-SC-S1C1 FACET Card
Specifications
- DB9 with RS-232/485 + DB9 with CAN bus.
- Serial port supports RS232, RS485 half/full duplex and can be configured independently.
- CAN bus supports CAN 2.0A Specifications and ISO 11898-2
- CAN bus bit rate of up to 1Mbit/s
- CAN bus isolation per UL 1577
- CAN bus transient immunity: 30kV/uS, isolated DC 5V power
- CANbus is driven by a dedicated 32bit microcontroller (ARM Cortex M0 - STM32F042C6) running open source firmware that can be upgraded
- CAN bus driverless operation in Windows
- CAN bus USB native device in Linux
- CAN bus over 10 ports can be installed
- CAN bus isolated DC 5V power
- CAN bus ambient Operation from –40°C to 85°C.
CAN bus and Serial connector Pinout
FC3-SC Rev 1.2 Extension schematic
Explanation:
DB9 Port #2
CAN #2 switches
SW3: Code - switch between UART/USB presentation
SW4: Term - Termination by 120 OM if needed
DB9 Port #1
SER #1 switches
SW8: Switch between RS232 and RS485
SW7: Switch between Full and Half duplex (for RS485)
Back to fitlet3 FACET Cards