Difference between revisions of "TEL-CANBUS"
From fit-PC wiki
(→TEL-CANBUS) (change visibility) |
|||
Line 31: | Line 31: | ||
==Block diagram== | ==Block diagram== | ||
[[File:TEL-CANBUS_Rev.1.0_block_Diagram.jpg|200px]] | [[File:TEL-CANBUS_Rev.1.0_block_Diagram.jpg|200px]] | ||
− | + | ==Connector Pinout== | |
− | + | [[File:TEL-CANBUS connector pinout.png|200px]] | |
<!-- | <!-- | ||
===Instructions=== | ===Instructions=== |
Revision as of 13:07, 27 October 2021
Contents
TEL-CANBUS
- Type: COM
- Config name: FQ
- Compulab part number: FT.Q_CAN
- Interface: COM
- TRIP: 2,3,4,5,6,7,7B,8,9
- Stacking: A, C
- Features: TEL-CANBUS provides a CANbus interface with isolation through a DB-9 connector
Specifications
- Single CAN device using DB9 connector
- Supports CAN 2.0A Specifications and ISO 11898-2
- Bit rate of up to 1Mbit/s
- Isolation per UL 1577
- Transient immunity: 30kV/uS, isolated DC 5V power
- CANbus is driven by a dedicated 32bit microcontroller (ARM Cortex M0 - STM32F042C6) running open source firmware that can be upgraded
- Driverless operation in Windows
- USB native device in Linux
- Over 10 ports can be installed
- Isolated DC 5V power
- Ambient Operation from –40°C to 85°C.
Configuration
- Two Code implementations in one device switchable by a DIP Switch.
- Default CANable USB CDC implementation & candleLight USB device implementation.
- DIP switch for enabling/disabling on-board 120 Ohm termination
- Upgradeable using build-in MCU bootloader and openly available tools. (Please follow update guide in GitHub)
Block diagram
Connector Pinout
Production files
Schematics
Assembly
Layout
Mechanical
Back to Tensor-PC TEL Modules