Changes

Jump to: navigation, search

Quick AMT Setup

179 bytes added, 13:18, 21 May 2019
* This manual instructs how to configure Intel AMT.* It applies to machine models: Intense PC | IPC2 | Airtop1. '''Quick AMT Setup for IPC2, Intense PC and uSVR'''
#Enter BIOS go to ADVANCED -> AMT Configuration and set "Enter Intel(R) MEBx Setup" to "Enabled"
#Exit saving changes -> System will boot ( one time ) to to MEBx AMT setup
#Enter "MEBx Login" -> using password "admin" and set the "Intel(R) ME New password " according with rules below
##At least 8 characters ( max32)
##At least one 7-bit ASCII non alpha-numeric character(e.g.'!','$',';') , but excluding ':' ,',' and '""' characters
##At least one lower case letter ('a','b'...'z') and at least one upper case letter ('A' ,'B'...'Z')
#Enter "Intel(R) AMT Standard Manageability Configuration" -> "Activate Network Access" and press "Y"
#Enter "Network Setup" -> "TCP/IP Settings" ->"Wired LAN IPV4 Configuration" -> "DHCP Mode" and set to "Disabled"
#Now set all IPs related settings and then press "ESC" four times - returning to main menu
'''Usage'''
#*Connect Intel AMT capable LAN port to the a network ( right one from :**Airtop - LAN2**IPC2 - LAN1**Intense PC - LAN closer to the rear)edge#*On the remote machine:##**Open browser and set address to http://your_ip''target IP address'':16992 when "your_iptarget IP address" was set previously in the AMT setup##**Press "Log On" and enter login/password -> "admin"/your_psw ''password'' when "your_pswpassword" was set previously in the AMT setup##**Now all system information/status/remote management menus are accessible including remote power on/off#*For remote KVM use "VNC Viewer Plus": http://www.realvnc.com/products/viewerplus/
Tamir
Administrator
1,586
edits
Retrieved from "https://fit-pc.com/wiki/index.php?title=Special:MobileDiff/2819...7177"