1. IPC2 BIOS reset:
::a. *Power down the PC and unplug the power cable.::b. *Open the service door (by screwing out one bolt) and remove it (with the storage).::c. *Reset the BIOS by pressing the low profile push button SW3 for 3 seconds.::d. *Install back the storage with the service door.::e. *Plug the power and power up the PC(either auto-on or pressing power button).
:: [[File:IPC2_BIOS_reset.jpg]]
2. Verify RAM memory modules are installed -
:: *The system will not boot without memory.
3. Try to answer the following questions:
*Are you able to power up without storage?
*IPC2 supports up to 7200 rpm HDD drives.
34. Try to answer the following questionsPower supply:::a. Are you able to *Verify the power up without storage?::bsupply is not damaged and functions properly. What type of storage being used in terms of RPM (in case of HDD)? :: Note that 7200rpm drives are not recommended due to lower *If you have another power nature of the PC, as such drives used supply use it to overload eliminate and determine the machinefailing side. 5400rpm drives at maximum must be used*In case you use other power supply make sure it provides uninterrupted power and stable grounding. 5.[[IPC2 BIOS Update]]
6. [http://www.fit-pc.com/web/support/rma/ RMA procedure]
4. [http[category://www.fit-pc.com/web/support/rma/ RMA procedureIPC2]]
