Changes
** State S0 - Active
** State S5 - SW Off
* '''mSATA-PCIe''': Switched between SATA and PCI Express interface on the full size mini PCIe slot.
* '''SB PCI Express Config''':
**'''PCI Express Root Port Clock Gating''': Enables/Disables PCI Express Root Port Clock Gating
**'''DMI Link ASPM Control''': The control of Active State Power Management of DMI link
**'''DMI Link Extended Sync Control''': The control of Extended Sync of SB side of the DMI link
**'''PCI Express Port i Config''': Control the PCI Express Root Port i
* '''SB USB Config''': Enables/Disables USB Port
* '''SB Azalia Config'''
** '''Azalia''': Control detection of the Azalia device
** '''Azalia PME Enabled''': Enables/Disables PME for Azalia
* '''SB Security Config'''
** '''GPIO Lockdown''': Enable/Disable the PCH GPIO lockdown feature
** '''RTC Lock''': Enable will lock bytes 38h-3Fh in the lower/upper 128-byte bank of RTC RAM
** '''BIOS Lock''': Enable/Disable the PCH BIOS lock enable feature. The whole BIOS region is not writable
** '''SMM Lock''': Enable/Disable SMM lock feature. It will lock the SMRAM and unable load SMM driver any more.
* '''Watchdog''': Enable/Disable Watchdog
==== Network Configuration ====
* '''TBDPCH Internal LAN''': Enable/Disable PCH internal LAN* '''TBDLAN OPROM Selection''': This is used to select LAN OPROM for quick boot minimal configuration* '''TBDWake on PCH LAN''': Enable PCH internal Wake on LAN capability at Moff* '''ASF Support''': Enable/Disable alert specification format
==== SuperIO Configuration ====
SuperIO settings conrtol:* '''TBDOnboard UART1''': Enabled always * '''TBDOnboard UART2''': This option controls the onboard UART2 address. When enabled UART2 uses address 0x2F8 and IRQ 3* '''TBDOnboard UART3''': This option controls the onboard UART3 address. When enabled UART3 uses address 0x3E8 and IRQ 4
==== AMT Configuration ====
Configure Active Management Technology parameters:* '''TBDIntel AMT''': * '''TBDAMT Wait Timer''': * '''TBDSOL Terminal Type''': * '''Enter Intel MEBx Setup''': * '''Un-Configure ME''': * '''Hide Un-Configure ME Confirmation''': * '''USB Provision''': * '''MEBX Resolution Settings''': ** '''Non-UI Text Mode resolution''': ** '''UI Text Mode resolution''': ** '''Graphic Mode resolution''':
==== ME Configuration ====
Configure Management Engine Technology parameters:* ME FW Version 9.5.30.1808* ME Firmware Intel ME 5MB firmware* '''Intel ME''': * '''TBDIntel AT''': * '''TBDME FW Downgrade''': * '''TBDME IFR Feature''':
==== Thermal Configuration ====
Thermal control sub-menu:* '''TBDCPU Thermal Configuration''': * '''TBDBi-directional PROCHOT#''': * '''TBDPROCHOT# OUT''': * '''PROCHOT Response''': * '''Disable VR Thermal Alert''': * '''ACPI 3.0 T-States''':
=== Security ===
