Difference between revisions of "IPC2B: USB3.0 Driver Installation Guide"
From fit-PC wiki
Line 3: | Line 3: | ||
==Instructions== | ==Instructions== | ||
− | + | 1. Install the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_Chipset.zip Chipset driver] before the USB3.0 driver | |
− | + | 2. Download the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_USB30.zip USB3.0 driver] | |
− | + | 3. Extract the downloaded package | |
− | + | 4. Run the '''OfflineSetup32.exe''' file for Windows 7 32bit or the '''OfflineSetup64.exe''' file for Windows 7 64bit | |
− | + | 5. Follow the on-screen instructions | |
− | + | 6. At the the end of installation process, reset the unit | |
− | + | 7. Enter the BIOS menu by pressing the '''[F2]''' key during boot | |
− | + | 8. Browse to | |
− | + | Advanced | |
South Bridge Configuration | South Bridge Configuration | ||
− | SB USB Config''' Menu. | + | '''SB USB Config''' Menu. |
set '''xHCI Mode''' to '''[Enabled]''' | set '''xHCI Mode''' to '''[Enabled]''' | ||
− | + | 9. Press the '''[F10]''' key for Save&Exit | |
− | + | 10. When Windows bootd up, open the downloaded package | |
− | + | 11. Run the '''Setup.exe''' file | |
− | + | 12. Follow the on-screen instructions | |
− | + | 13. At the the end of installation process, reset the unit | |
[[Category:IPC2]] | [[Category:IPC2]] | ||
[[Category:software]] | [[Category:software]] | ||
[[Category:Application notes]] | [[Category:Application notes]] |
Revision as of 13:50, 15 October 2018
- This application note provides a step by step guide to install USB3.0 drivers over Windows 7.
- Applicable to IPC2-Broadwell machines.
Instructions
1. Install the Chipset driver before the USB3.0 driver 2. Download the USB3.0 driver 3. Extract the downloaded package 4. Run the OfflineSetup32.exe file for Windows 7 32bit or the OfflineSetup64.exe file for Windows 7 64bit 5. Follow the on-screen instructions 6. At the the end of installation process, reset the unit 7. Enter the BIOS menu by pressing the [F2] key during boot 8. Browse to
Advanced South Bridge Configuration SB USB Config Menu. set xHCI Mode to [Enabled]
9. Press the [F10] key for Save&Exit 10. When Windows bootd up, open the downloaded package 11. Run the Setup.exe file 12. Follow the on-screen instructions 13. At the the end of installation process, reset the unit