Changes
==Instructions==
1. Install the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_Chipset.zip Chipset driver] before the USB3.0 driver
2. Download the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_USB30.zip USB3.0 driver]
3. Extract the downloaded package
4. Run the '''OfflineSetup32.exe''' file for Windows 7 32bit or the '''OfflineSetup64.exe''' file for Windows 7 64bit
5. Follow the on-screen instructions
6. At the the end of installation process, reset the unit
7. Enter the BIOS menu by pressing the '''[F2]''' key during boot
8. Browse toIn the BIOS menu browse as follows: >Advanced >>South Bridge Configuration >>'''SB USB Config''' Menu. *set '''xHCI Mode''' to '''[Enabled]'''
9. Press the '''[F10]''' key for Save&Exit
10. When Windows bootd boots up, open the downloaded package
11. Run the '''Setup.exe''' file
12. Follow the on-screen instructions
13. At the the end of installation process, reset the unit
[[Category:IPC2]]
[[Category:software]]
[[Category:Application notes]]
