Changes

* This application note provides a step by step guide to install USB3.0 drivers over Windows 7.* Applicable to IPC2-Broadwell machines. ==Instructions==1. Install the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_Chipset.zip Chipset driver ] before the USB3.0 driver* 2. Download the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_USB30.zip USB3.0 driver]* 3. Extract the downloaded package 4. Run the '''OfflineSetup32.exe''' file for Windows 7 32bit or the '''OfflineSetup64.exe''' file for Windows 7 64bit* 5. Follow the on-screen instructions* 6. At the the end of installation process, reset the unit* 7. Enter the BIOS menu by pressing the F '''[F2]''' key during the boot* Browse to 8. In the '''BIOS menu browse as follows: >Advanced - >> South Bridge Configuration - > >'''SB USB Config''' menu and Menu. *set the '''xHCI Mode''' setting to '''[Enabled]'''* 9. Press the '''[F10 ]''' key for Save&Exit 10. When Windows boots up, open the downloaded package 11. Run the '''Setup.exe''' file 12. Follow the on-screen instructions 13. At the the end of installation process, reset the unit  [[Category:IPC2]][[Category:software]][[Category:Application notes]]