Changes

* This application note provides a step by step guide to install USB3.0 drivers over Windows 7.* Applicable to IPC2-Broadwell machines. ==Instructions==1. Install the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_Chipset.zip Chipset driver] before the USB3.0 driver 2. Download the * [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_USB30.zip USB3.0 driver] 3. Extract the downloaded package 4. Run the '''OfflineSetup32.exe''' file for Windows 7 32bit or the '''OfflineSetup64.exe''' file for Windows 7 64bit 5. Follow the on-screen instructions 6. At the the end of installation process, reset the unit 7. Enter the BIOS menu by pressing the '''[F2]''' key during boot 8. In the BIOS menu browse as follows: >Advanced >>South Bridge Configuration >>'''SB USB Config''' Menu. *set '''xHCI Mode''' to '''[Enabled]'''9. Press the '''[F10]''' key for Save&Exit 10. When Windows boots up, open the downloaded package 11. Run the '''Setup.exe''' file 12. Follow the on-screen instructions 13. At the the end of installation process, reset the unit  [[Category:IPC2]][[Category:software]][[Category:Application notes]]