Difference between revisions of "IPC2B: USB3.0 Driver Installation Guide"
From fit-PC wiki
Line 18: | Line 18: | ||
8. Browse to | 8. Browse to | ||
− | Advanced | + | >Advanced |
− | South Bridge Configuration | + | >>South Bridge Configuration |
− | '''SB USB Config''' Menu. | + | >>'''SB USB Config''' Menu. |
− | set '''xHCI Mode''' to '''[Enabled]''' | + | * set '''xHCI Mode''' to '''[Enabled]''' |
9. Press the '''[F10]''' key for Save&Exit | 9. Press the '''[F10]''' key for Save&Exit | ||
Revision as of 06:21, 16 October 2018
- This application note provides a step by step guide to install USB3.0 drivers over Windows 7.
- Applicable to IPC2-Broadwell machines.
Instructions
1. Install the Chipset driver before the USB3.0 driver
2. Download the USB3.0 driver
3. Extract the downloaded package
4. Run the OfflineSetup32.exe file for Windows 7 32bit or the OfflineSetup64.exe file for Windows 7 64bit
5. Follow the on-screen instructions
6. At the the end of installation process, reset the unit
7. Enter the BIOS menu by pressing the [F2] key during boot
8. Browse to
>Advanced >>South Bridge Configuration >>SB USB Config Menu. * set xHCI Mode to [Enabled]
9. Press the [F10] key for Save&Exit
10. When Windows boots up, open the downloaded package
11. Run the Setup.exe file
12. Follow the on-screen instructions
13. At the the end of installation process, reset the unit