Difference between revisions of "Fitlet2 BIOS reset for rev 1.1 and older"
From fit-PC wiki
(Created page with "*For BIOS version FLT2.0.40.01.00 and above. Reset BIOS default following the following procedure for SBC revisions 1.1: #Unplug power ca...") (change visibility) |
|||
Line 1: | Line 1: | ||
− | + | == fitlet2 SBC revisions 1.1 == | |
− | + | ||
− | + | ||
#Unplug power cable from the fitlet2 | #Unplug power cable from the fitlet2 | ||
Line 17: | Line 15: | ||
#Plug Power cable | #Plug Power cable | ||
− | + | BIOS settings should be reset to defaults. | |
− | + | ||
− | + | ||
− | + | ||
− | + | == BIOS version older than FLT2.0.40.01.00 == | |
− | + | ||
+ | # Disconnect the power core | ||
# Remove all the storage devices (internal and external). | # Remove all the storage devices (internal and external). | ||
# Boot the system and wait for ~15 seconds to ensure the system booted to the BIOS menu. | # Boot the system and wait for ~15 seconds to ensure the system booted to the BIOS menu. |
Revision as of 08:08, 17 May 2020
fitlet2 SBC revisions 1.1
- Unplug power cable from the fitlet2
- Remove the 4x Phillips Chassis screws
- Remove bottom and top cover
- Remove the RAM stick
- Plug in power cable (should turn on automatically), and Wait ~10 seconds
- Unplug power cable
- Assemble back the RAM stick
- Carefully unplug the RTC Battery from the 2pin connector
- Plug power cable (should turn on automatically)
- Shutdown the PC
- Unplug the power cable
- Plug the RTC Battery back in
- Plug Power cable
BIOS settings should be reset to defaults.
BIOS version older than FLT2.0.40.01.00
- Disconnect the power core
- Remove all the storage devices (internal and external).
- Boot the system and wait for ~15 seconds to ensure the system booted to the BIOS menu.
- Press F3 key and after that the Enter key to load the default menu settings
- Press F4 key and after that the Enter key to save and exit
- The system should restart and boot with default menu settings.