Changes
/* 4. fitlet2 BIOS reset */
</div>
Reset BIOS default following the following procedure('''works for SBC revisions 1.1 only'''):
# Unplug power cable from the fitlet2
#Remove the 4x Phillips Chassis screws
#Remove and bottom and top cover
#Unplug power cable
#Assemble back the DIMM stick
#Check which revision Press the fitlet2 SBC is – RTC reset button.#Plug power cable (should be automatically turned on the print side, should be printed on top of the board (where the DIMM is located)#'''If the fitlet2 SBC Revision is 1.2''' <!--> Press the RTC reset button.##Otherwise '''if the fitlet2 SBC Revision is 1.1''' --> carefully unplug the RTC Battery from the 2pin connector.
#Plug power cable (should turn on automatically)
#Continue steps for revision 1.1 (RTC battery had to be disconnected):
##Plug the RTC Battery back in
##Plug Power cable
-->
At this stage the BIOS settings should be reset to defaults.
