(20 intermediate revisions by 2 users not shown) | |||
Line 1: | Line 1: | ||
− | * Download the | + | * This application note provides a step by step guide to install USB3.0 drivers over Windows 7. |
+ | * Applicable to IPC2-Broadwell machines. | ||
+ | |||
+ | ==Instructions== | ||
+ | 1. Install the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_Chipset.zip Chipset driver] before the USB3.0 driver | ||
+ | |||
+ | 2. Download the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_USB30.zip USB3.0 driver] | ||
+ | |||
+ | 3. Extract the downloaded package | ||
+ | |||
+ | 4. Run the '''OfflineSetup32.exe''' file for Windows 7 32bit or the '''OfflineSetup64.exe''' file for Windows 7 64bit | ||
+ | |||
+ | 5. Follow the on-screen instructions | ||
+ | |||
+ | 6. At the the end of installation process, reset the unit | ||
+ | |||
+ | 7. Enter the BIOS menu by pressing the '''[F2]''' key during boot | ||
+ | |||
+ | 8. In the BIOS menu browse as follows: | ||
+ | >Advanced | ||
+ | >>South Bridge Configuration | ||
+ | >>'''SB USB Config''' Menu. | ||
+ | *set '''xHCI Mode''' to '''[Enabled]''' | ||
+ | 9. Press the '''[F10]''' key for Save&Exit | ||
+ | |||
+ | 10. When Windows boots up, open the downloaded package | ||
+ | |||
+ | 11. Run the '''Setup.exe''' file | ||
+ | |||
+ | 12. Follow the on-screen instructions | ||
+ | |||
+ | 13. At the the end of installation process, reset the unit | ||
+ | |||
+ | |||
+ | [[Category:IPC2]] | ||
+ | [[Category:software]] | ||
+ | [[Category:Application notes]] |
Latest revision as of 06:32, 16 October 2018
- This application note provides a step by step guide to install USB3.0 drivers over Windows 7.
- Applicable to IPC2-Broadwell machines.
Instructions
1. Install the Chipset driver before the USB3.0 driver
2. Download the USB3.0 driver
3. Extract the downloaded package
4. Run the OfflineSetup32.exe file for Windows 7 32bit or the OfflineSetup64.exe file for Windows 7 64bit
5. Follow the on-screen instructions
6. At the the end of installation process, reset the unit
7. Enter the BIOS menu by pressing the [F2] key during boot
8. In the BIOS menu browse as follows:
>Advanced >>South Bridge Configuration >>SB USB Config Menu. *set xHCI Mode to [Enabled]
9. Press the [F10] key for Save&Exit
10. When Windows boots up, open the downloaded package
11. Run the Setup.exe file
12. Follow the on-screen instructions
13. At the the end of installation process, reset the unit