Difference between revisions of "IPC2B: USB3.0 Driver Installation Guide"

From fit-PC wiki
Jump to: navigation, search
Line 11: Line 11:
 
# Enter the BIOS menu by pressing the '''[F2]''' key during boot
 
# Enter the BIOS menu by pressing the '''[F2]''' key during boot
 
# Browse to
 
# Browse to
  Advanced -> South Bridge Configuration -> SB USB Config''' Menu.  
+
  Advanced
set the '''xHCI Mode''' setting to '''Enabled'''
+
    South Bridge Configuration
 +
        SB USB Config''' Menu.  
 +
        set '''xHCI Mode''' to '''[Enabled]'''
 
# Press the '''[F10]''' key for Save&Exit
 
# Press the '''[F10]''' key for Save&Exit
 
# When Windows bootd up, open the downloaded package
 
# When Windows bootd up, open the downloaded package

Revision as of 13:47, 15 October 2018

  • This application note provides a step by step guide to install USB3.0 drivers over Windows 7.
  • Applicable to IPC2-Broadwell machines.

Instructions

  1. Install the Chipset driver before the USB3.0 driver
  2. Download the USB3.0 driver
  3. Extract the downloaded package
  4. Run the OfflineSetup32.exe file for Windows 7 32bit or the OfflineSetup64.exe file for Windows 7 64bit
  5. Follow the on-screen instructions
  6. At the the end of installation process, reset the unit
  7. Enter the BIOS menu by pressing the [F2] key during boot
  8. Browse to
Advanced
    South Bridge Configuration
       SB USB Config Menu. 
       set xHCI Mode to [Enabled]
  1. Press the [F10] key for Save&Exit
  2. When Windows bootd up, open the downloaded package
  3. Run the Setup.exe file
  4. Follow the on-screen instructions
  5. At the the end of installation process, reset the unit