Difference between revisions of "IPC2B: USB3.0 Driver Installation Guide"
From fit-PC wiki
Line 3: | Line 3: | ||
==Instructions== | ==Instructions== | ||
− | + | # Install the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_Chipset.zip Chipset driver] before the USB3.0 driver | |
− | + | # Download the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_USB30.zip USB3.0 driver] | |
− | + | # Extract the downloaded package | |
− | + | # Run the '''OfflineSetup32.exe''' file for Windows 7 32bit or the '''OfflineSetup64.exe''' file for Windows 7 64bit | |
− | + | # Follow the on-screen instructions | |
− | + | # At the the end of installation process, reset the unit | |
− | + | # Enter the BIOS menu by pressing the '''[F2]''' key during boot | |
− | + | # Browse to | |
− | + | '''Advanced -> South Bridge Configuration -> SB USB Config''' Menu. | |
− | + | set the '''xHCI Mode''' setting to '''Enabled''' | |
− | + | # Press the '''[F10]''' key for Save&Exit | |
− | + | # When Windows bootd up, open the downloaded package | |
− | + | # Run the '''Setup.exe''' file | |
+ | # Follow the on-screen instructions | ||
+ | # At the the end of installation process, reset the unit | ||
[[Category:IPC2]] | [[Category:IPC2]] | ||
[[Category:software]] | [[Category:software]] | ||
[[Category:Application notes]] | [[Category:Application notes]] |
Revision as of 13:46, 15 October 2018
- This application note provides a step by step guide to install USB3.0 drivers over Windows 7.
- Applicable to IPC2-Broadwell machines.
Instructions
- Install the Chipset driver before the USB3.0 driver
- Download the USB3.0 driver
- Extract the downloaded package
- Run the OfflineSetup32.exe file for Windows 7 32bit or the OfflineSetup64.exe file for Windows 7 64bit
- Follow the on-screen instructions
- At the the end of installation process, reset the unit
- Enter the BIOS menu by pressing the [F2] key during boot
- Browse to
Advanced -> South Bridge Configuration -> SB USB Config Menu. set the xHCI Mode setting to Enabled
- Press the [F10] key for Save&Exit
- When Windows bootd up, open the downloaded package
- Run the Setup.exe file
- Follow the on-screen instructions
- At the the end of installation process, reset the unit