Changes

# Connect the prepared USB flash device to the fitlet and boot (it should be connected to the USB2 connector only). # Press the DEL key during boot to enter BIOS setup utilitymenu.# Set 1st boot priority to USB Key.Under Save & Exit tab, select the option “Launch EFI Shell from filesystem device”# Save When the system enters the UEFI mode, type the command “flash flt” and exitpress Enter.# The fitlet should boot to DOS from the USB flash deviceBIOS flashing process will start.# Type flash:'''Note:''' At the start of the process, the system will hang for 1 minute. This is expected behavior. Please, don’t interrupt it.bat# Wait until completionWhen the process ends, type the command “reset” and press Enter.# Disconnect Press the USB flash device DEL key during the restart and rebootenter the BIOS menu.# Under Save & Exit tab, select the option “Restore Defaults” and after that “Save Changes and Reset”.