Last modified on 15 July 2015, at 11:01

Quick AMT Setup

Revision as of 11:01, 15 July 2015 by Maxim (Talk | contribs) (Created page with ''''Quick AMT Setup for IPC2, Intense PC and uSVR''' #Enter BIOS go to ADVANCED -> AMT Configuration and set "Enter Intel(R) MEBx Setup" to "Enabled" #Exit saving changes -> Syst...')

(change visibility) (diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Quick AMT Setup for IPC2, Intense PC and uSVR

  1. Enter BIOS go to ADVANCED -> AMT Configuration and set "Enter Intel(R) MEBx Setup" to "Enabled"
  2. Exit saving changes -> System will boot ( one time ) to to MEBx AMT setup
  3. Enter "MEBx Login" -> using password "admin" and set the "Intel(R) ME New password " according with rules below
    1. At least 8 characters ( max32)
    2. At least one digit character(0-9)
    3. At least one 7-bit ASCII non alpha-numeric character(e.g.'!','$',';') , but excluding ':' ,',' and '""' characters
    4. At least one lower case letter ('a','b'...'z') and at least one upper case letter ('A' ,'B'...'Z')
  4. Enter "Intel(R) AMT Configuration" -> "Activate Network Access" and press "Y"
  5. Enter "Network Setup" -> "TCP/IP Settings" ->"Wired LAN IPV4 Configuration" -> "DHCP Mode" and set to "Disabled"
  6. Now set all IPs related settings and then press "ESC" four times - returning to main menu
  7. Press "MEBx Exit" and wait until reboot
  8. Unplug your system for 20-30s and then plug it back

Usage

  1. Connect Intel LAN to the network ( right one from the rear)
  2. On the remote machine:
    1. Open browser and set address to http://your_ip:16992 when "your_ip" was set previously in the AMT setup
    2. Press "Log On" and enter login/password -> "admin"/your_psw when "your_psw" was set previously in the AMT setup
    3. Now all system information/status/remote management menus are accessible including remote power on/off
  3. For remote KVM use "VNC Viewer Plus": http://www.realvnc.com/products/viewerplus/