Difference between revisions of "Intense PC (MintBox 2) security update 170523"
From fit-PC wiki
(5 intermediate revisions by 2 users not shown) | |||
Line 2: | Line 2: | ||
#*[http://fit-pc.com/download/intense-pc/bios/21-05-2017/ipc_2.2.400.3.img.zip BIOS update for Intense PC (MintBox 2)] | #*[http://fit-pc.com/download/intense-pc/bios/21-05-2017/ipc_2.2.400.3.img.zip BIOS update for Intense PC (MintBox 2)] | ||
# Extract the image file from the archive. | # Extract the image file from the archive. | ||
− | + | <!-- prepare bootable USB drive --> | |
− | + | {{How to prepare bootable USB drive}} | |
− | + | ||
− | + | ||
− | + | ||
− | + | ||
# Boot Intense PC or MintBox2 from the USB Flash drive. | # Boot Intense PC or MintBox2 from the USB Flash drive. | ||
# When boots up into FreeDOS command line run ''BIOS_UPD.bat'' and wait for it's completion without errors. | # When boots up into FreeDOS command line run ''BIOS_UPD.bat'' and wait for it's completion without errors. |
Latest revision as of 14:03, 20 June 2017
- Download the latest Intense PC BIOS image:
- Extract the image file from the archive.
- Prepare bootable USB flash drive:
- Windows users - use Win32DiskImager utility: Win32DiskImager
- Linux users:
- Run this command to figure out what device name was assigned to the USB drive: $ ls -all /dev/disk/by-id/
- Assuming the USB drive was detected as /dev/sdx write the image on it by typing: $ sudo dd if=filename.img of=/dev/sdx bs=1MB
- Boot Intense PC or MintBox2 from the USB Flash drive.
- When boots up into FreeDOS command line run BIOS_UPD.bat and wait for it's completion without errors.
- After it the system will boot again into FreeDOS run ME_LOCK.bat and wait for it's completion without errors.
- Wait until message "Please disconnect this system from power for 15 sec for completion"
- Power cycle the computer.