IPC3 Troubleshooting

1. IPC3 BIOS reset:

Power down the PC and unplug the power cable.
Open the service door (by screwing out one bolt) and remove it (with the storage).
Reset the BIOS by pressing the low profile push button SW2 (near the LAN ports) for 3 seconds.
Install back the storage with the service door.
Plug the power and power up the PC (either auto-on or pressing power button).

2. Verify RAM memory modules are installed - The system will not boot without memory.

3. Try to power up without storage. Is the PC boot up?

IPC3 supports up to 7200 rpm HDD drives.

4. Power supply:

Verify the power supply is not damaged and functions properly.
If you have another power supply use it to eliminate and determine the failing side.
In case you use other power supply make sure it provides uninterrupted power and stable grounding.

Navigation menu