Difference between revisions of "IPC2B: USB3.0 Driver Installation Guide"
From fit-PC wiki
Line 11: | Line 11: | ||
# Enter the BIOS menu by pressing the '''[F2]''' key during boot | # Enter the BIOS menu by pressing the '''[F2]''' key during boot | ||
# Browse to | # Browse to | ||
− | + | Advanced -> South Bridge Configuration -> SB USB Config''' Menu. | |
− | + | set the '''xHCI Mode''' setting to '''Enabled''' | |
# Press the '''[F10]''' key for Save&Exit | # Press the '''[F10]''' key for Save&Exit | ||
# When Windows bootd up, open the downloaded package | # When Windows bootd up, open the downloaded package |
Revision as of 13:47, 15 October 2018
- This application note provides a step by step guide to install USB3.0 drivers over Windows 7.
- Applicable to IPC2-Broadwell machines.
Instructions
- Install the Chipset driver before the USB3.0 driver
- Download the USB3.0 driver
- Extract the downloaded package
- Run the OfflineSetup32.exe file for Windows 7 32bit or the OfflineSetup64.exe file for Windows 7 64bit
- Follow the on-screen instructions
- At the the end of installation process, reset the unit
- Enter the BIOS menu by pressing the [F2] key during boot
- Browse to
Advanced -> South Bridge Configuration -> SB USB Config Menu. set the xHCI Mode setting to Enabled
- Press the [F10] key for Save&Exit
- When Windows bootd up, open the downloaded package
- Run the Setup.exe file
- Follow the on-screen instructions
- At the the end of installation process, reset the unit