Page 1 of 1
fitPC2i SATA connection
Posted: Mon Apr 22, 2013 8:32 am
by sahamzah
Hi,
I would like to connect my SATA hard drive to fitPC2i connector via onboard P30 pin holes.
Can you recommend the suitable socket?
An what is the pin assignment for the pin holes since I cannot find it in the manual.
Tq
Re: fitPC2i SATA connection
Posted: Thu Apr 25, 2013 7:31 am
by gabrielh
fitPC2i supplied with such a connector. Are you talking about fitPC2 SBC?
Re: fitPC2i SATA connection
Posted: Thu Apr 25, 2013 7:49 am
by sahamzah
Yes, the SBC type that is used in Darwin OP Humanoid.
Re: fitPC2i SATA connection
Posted: Thu Apr 25, 2013 2:13 pm
by gabrielh
Please contact
sales@fit-pc.com for details.
Re: fitPC2i SATA connection
Posted: Fri Apr 26, 2013 7:37 am
by sahamzah
Ok. I will contact sales but at the same time since I need the SATA interfacing working urgently, can I have the SATA pin assignment onboard fitPC2i SBC? I will make my own connector.
Re: fitPC2i SATA connection
Posted: Mon Apr 29, 2013 10:18 am
by gabrielh
Sure
P1-GND
p2-Sata TX+
p3-Sata TX-
p4-GND
P5-Sata RX-
P6-Sata RX+
p7-GND
P8-NC
P9,10- +5V
P11-NC
p12-NC
Re: fitPC2i SATA connection
Posted: Mon Apr 29, 2013 10:50 am
by sahamzah
Thanks for the pin assignment.
I was informed by your sales department that the type of connector is ADP-SATA but they only sell in volume.
Do you know where can I purchase only for small quantity (5 units)
Re: fitPC2i SATA connection
Posted: Wed May 01, 2013 8:39 am
by gabrielh
This is a custom PCB made by a Compulab. You can check availability at our resellers