fit-IoT Users Forum

Finally working after replacement. Thanks to all who helped me. /dev/lirc0 is registered as expected immediately after the first boot. It was quite frustrating experience but I'm satisfied with the prompt customer service. **EDIT** I just found that my replaced Fit-PC2's power button is dead. Maybe ...

@denis: Hi Denis, I finally did a fresh-install of Ubuntu 9.10 with Fit-PC2 updates. Now I'm a bit worried that my receiver module has some hardware problem, after doing some tests below. All the packages were installed from the official Ubuntu and Fit-PC2 repositories only.(no source-compiled.) # u...

@fly:
Thanks a lot. Your information was really helpful.
It seems that I need to test with Compulab's 9.10 first to make sure that the receiver is properly working.
I will post again if I make any progress.
Cheers, K.

@Denis: Thanks, I'll try it and post if it works. @fly: I tried with your procedure but the problem is that I don't have /dev/lirc0 so I manually created a node with "mknod /dev/lirc0 c 61 0". Then I ran "irrecord -n -f -d /dev/lirc0 /etc/lircd2.conf" but it says: # irrecord -n -d /dev/lirc0 /etc/li...

bump.

@denis : Is the module in Compulab's 9.10 very different from the generic one? I found in an official document https://help.ubuntu.com/community/LIRC that says if I get the receiver's vendor and remote id by running lsusb, I can manually recompile the lirc source to make it support. The problem for ...

Hello, I have Fit-PC2 1.6Ghz with bios version 23-Dec-2009. I believe it is rev 1.21 as serial number starts with 091XXX-XXX. I've followed fly's thread ( http://www.fit-pc2.com/forum/viewtopic.php?f=58&t=1819 ) to install my 10.04 LTS 32bit and successfully configured video settings. My problem rig...